Operating Your Fan - HAMPTON BAY NORTH SHORELINE Guía De Uso Y Mantenimiento

Assembly - Attaching the Light Kit Fitter Assembly (continued)
4
Assembly without the light kit
IMPORTANT: It is critical to attach the switch cup using the
quick connector. The fan will not operate unless the light kit is
connected to the fan.
□
Remove the four light kit mounting screws (RR) on the
black bracket below the fan-motor assembly (D).
□
In order to use the fan without the light kit, remove the
switch cup (SS) from the top of the light kit fitter assembly
(E) by removing the center hex nut and washer inside
the switch cup, and then thread the switch cup off of the
threaded nipple on the top of the light kit fitter assembly
(E).
□
Press the plastic cap (GG) (provided) into the center hole of
the switch cup (SS).
□
Position the switch cup (SS) onto the black bracket and
reinstall the light kit mounting screws (RR).
□
Attach the pull chain extensions (FF) to the fan pull chains.

Operating Your Fan

The pull chain controls the fan speed as follows:
1 pull - High, 2 pulls - Medium, 3 pulls - Low, and 4 pulls - Off
Speed settings for warm or cool weather depend on factors such as
room size, ceiling height, number of fans, and so on.
NOTE: Wait for the fan to stop before reversing the direction of blade
rotation.
The slide switch (XX) controls the direction: forward (switch left) or
reverse (switch right).
A. Warm weather - (Forward) A downward airflow creates a cooling
effect. This allows you to set your air conditioner on a higher setting
without affecting your comfort.
B. Cool weather - (Reverse) An upward airflow moves warm air off of the
ceiling. This allows you to set your heating unit on a lower setting without
affecting your comfort.
D
SS
GG
FF
XX
XX
13
Please contact 1-855-HD-HAMPTON for further assistance.
RR
A. Warm weather
B. Cool weather
HAMPTONBAY.COM