HAMPTON BAY NORTH SHORELINE Guía De Uso Y Mantenimiento página 8

Assembly - Close-to-Ceiling Mount
1
Preparing for mounting
□
Remove the canopy ring (L) from the canopy (C) by turning the
ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (JJ) located in the "L shaped"
slots.
□
Remove and save the two canopy screws (KK) in the round
holes. This will enable you to remove the mounting bracket (A).
□
Remove the decorative canopy bottom cover (N) from the
canppy (C) by depressing the three studs located inside the
bottom of the canopy.
JJ
Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock
or personal injury, mount to an outlet box marked
"Acceptable for fan support of 35 lbs. (15.9 Kg) or less,"
and use the screws provided with the outlet box.
NOTE: The mounting bracket (A) is designed to slide into
place on an outlet box with the outlet box screws (NN)
installed.
□
Loosen the two mounting screws (NN) in the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Slide the mounting bracket (A) on to the mounting screws (NN)
and center the mounting bracket (A) in relation to the outlet box.
If necessary, use leveling washers (not included) between the
slide-on mounting bracket (A) and the outlet box. The flat side
of the slide-on mounting bracket (A) should face toward the
outlet box, as shown.
□
Securely tighten the two mounting screws (NN).
2
□
□
□
□
A
KK
C
N
L
8
Routing the wires
Remove three of the six screws and lock washers (MM)
(every other one) securing the motor collar (M) to the top of
the fan-motor assembly (D).
Route the wires exiting the top of the fan-motor assembly
(D) through the rubber gasket (DD) aligning the holes in the
rubber gasket (DD) with the three screw holes in the fan-
motor assembly (D).
Route the wires exiting the top of the fan-motor assembly
(D) through the canopy ring (L), and the canopy (C) (make
sure the slot openings for the canopy ring and canopy are on
top. Place the canopy (C) over the collar (M) at the top of the
motor assembly (D).
Align the mounting holes with the holes in the fan-motor
assembly (D) and fasten, using the three screws and lock-
washers (MM) removed previously. Tighten the mounting
screws securely.
MM
L
C
DD
M
D