Level One WRE-8011E Guía De Instalación Rápida página 10

5. Check if the Wifi Signal Strength is OFF, the WRE-8011E isn't connected
and suitable for Internet Connections. Please repeat steps of WPS Pairing or
follow next step to have it connected and suitable for Internet Connections.
If the WRE-8011E WiFi signal strength LED isn't ON, please repeat steps of
WPS Pairing or configure the WRE-8011E through Advanced
Configuration below.
STEP 4 Advanced Configuration
From any of the LAN computers connected to , launch your web browser, type
the following URL in the web address (or location) box, and press [Enter] on
your keyboard:
http://repeater.nw
Repeater Mode (Extend your Wireless Network
1. Check on Select ratio of SSID of the front AP and click on Next>> button.
(Figure 7)
2. Please wait... 140 s. (Figure 8)
3. Enter Wifi password of the front AP and then click on Connect
button.(Figure 9)
AP Mode (Extend your Wired Network to allow wireless devices to connect
your wired network using Wi-Fi)
1. Check on TCP/IP Settings -> LAN SETTING from left menu. (Figure 10)
2. Select on Client from DHCP drop-down list.
3. Click on Save & Apply button. (Figure 11)
4. Click on Reboot Now button.
5. Change setting successfully! Do not turn off or reboot the Device during
this time. Please wait 20 seconds ... (Figure 12)
6. Please disconnect the Ethernet Cable from PC and connect it to the LAN
port of xDSL/Cable Modem.
7. Please wait for 2 minutes.
8. Now, the WRE-8011E has been configured completely, and suitable for
Internet Connections.
7