English - Level One WRE-8011E Guía De Instalación Rápida

English

STEP 1 Connection of WiFi Range Extender
1. Connect the Ethernet cable to LAN Port
Connect the supplied RJ45 Ethernet cable from your PC's Ethernet
port to any of the WRE-8011E LAN Port.
2. Connect the WRE-8011E to your wall-mounted power outlet.
STEP 2 Configuration Procedures
Before starting the WRE-8011E configuration, please kindly configure the PC
computer as below, to have automatic IP address / DNS Server.
For Windows 10-32/64
1. Right click on Network icon , then click "Open Network and Sharing
Center" . (Figure 1)
2. In the Control Panel Home, click on "Change adapter settings" to
continue. (Figure 2)
3. Single RIGHT click on "Ethernet", then click "Properties".(Figure 3)
Double click on "Internet Protocol Version 4 (TCP/IPv4)". (Figure 4)
4. Check "Obtain an IP address automatically" and "Obtain DNS server
address automatically" then click on "OK" to continue.(Figure 5)
STEP 3 Quick Setup using the WPS Button
WPS Pairing between WRE-8011E and Wireless xDSL/Cable Modem. (Figure 6)
1. Press WPS button on Wireless xDSL/Cable Modem.
2. Press WPS button on WRE-8011E for 3 seconds and release WPS button.
Now the WPS LED is blinking and the WRE-8011E is donig WPS Pairing with
Wireless xDSL/Cable Modem.
Make sure to press the button within 120 seconds (2 minutes) after
pressing the Wireless xDSL/Cable Modem's WPS button.
3. Once the WRE-8011E finished doing WPS Pairing with Wireless xDSL/Cable
Modem, the Wifi Signal Strength LED is ON. The status of Wifi signal strength
LED varies depending on the Wifi signal strength between WRE-8011E and
Wireless xDSL/Cable Modem.
4. Check if the Wifi Signal Strength LED of WRE-8011E is ON, the WRE-8011E is
connected and suitable for Internet Connections.
6