bosal 033-681 Manual De Montaje página 19

The fact that the towing bracket has been mounted to the vehicle must be entered in the
vehicle papers at the next possible opportunity. The mounting instructions must be added to
the vehicle papers.
General Installation Intructions:
If present, remove insulating compound and/or underseal in the area of the towing bracket
contact surfaces. Coat bare bodywork with anti-corrosion paint.
Mount 7-pin electrical system as per DINV 72570.
Mount 13-pin electrical system as per ISO 11446.
Retighten all mounting bolts of the towing bracket after aprox. 1000 towing km. Please note,
that after mounting the drawbar the mass of your vehicle will change.
Mounting instructions:
Dismantle the rear bumper, let down exhaust manifold and dismantle the heat-shield of
–
the exhaust manifold, too.
Place the distance pipes from the outside into the factory made holes on both sides of the
–
beam of chassis (at points „a"), then match the accessory plates No. 2,3 to these fixing
points and loosely fix them to the inside of the beam of chassis. Place the washers No. 4
to the outside of the chassis.
Match the body of the drawhook (1) to the factory made holes on the rear panel and
–
loosely screw it at point „b" to the accessory plates (2,3) by means of the enclosed fixing
elements according to the drawing.
Mount coupler ball onto the draw bar.
–
Finalise the tightening of the screws and drill the bottom plate of the car to inlet the electric
–
cable.
Reinstall the heat-shield and then the exhaust manifold. Before reinstalling the bumper,
–
cut out a piece of it with size suitable for the supporting ball.
By means of opening the rear cable bundle, connect the electric wires according to the
–
regulations.
Only specialised workshops are allowed to install the drawhook.
–
19