Main n ce & Care
Belt removal and replacement
1. Turn off the machine and unplug it from the
outlet.
2. Remove the dirty and clean water tanks from
the base of the machine.
3. While standing behind the unit, lay the unit
on its' side (cord side up)
4. Looking at the bottom of unit, find the back
center of the brush carriage where the carriage
latch is located. It is between the brush assem-
bly and the front wheels.
5. Pull brush carriage towards you with
one hand until it stops, then pinch the carriage
latch with other hand while pulling the carriage
towards you. The carriage should swing out to
access belt cover.
6. Remove three screws from cover. Lift and
remove to access brush carriage.
7. Turn the belt inward towards the large pulley
while lifting out.
8. Place new belt over small pulley first and
then slip the belt over the large pulley.
NOTE: Test the brush roll to make sure it spins
freely before moving to the next step.
9. Replace the brush carriage and screws.
10. Push brush carriage back into place
making sure the carriage latch locks back into
place.
www.BISSELL.com
10
WARNING
To reduce the risk of electric shock, turn power switch
o and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
3.
4.
6A.
7.
9.
5.
6B.
8.
10.