Bissell BIG GREEN DEEP CLEANIGN MACHINE 86T3 Serie Guia Del Usuario página 11

Main n ce & Care
Brush removal and replacement
1. Turn OFF (0) the machine and unplug from
the outlet.
2. Remove the dirty and clean water tanks from
the base of the machine.
3. While standing behind the unit, lay the unit
on its' side (cord side down).
4. Looking at the bottom of the unit, find the
center of the brush carriage where the carriage
latch is located. It is between the brush
assembly and wheels.
5. Pull the brush carriage towards you with
one hand until it stops. Pinch the carriage latch
with the other hand while pulling the carriage
towards you. The carriage should swing out to
access brush end cover.
6. Remove three screws from endcap. Pull
endcap off to release brush roll.
7. With cover removed, the brush comes
out easily by tilting the loose end out of the
carriage.
8. To replace the brush roll back into the unit,
place the large open end of the brush onto the
carriage and tilt opposite end back into place.
9. With the brush sitting relatively straight up
and down by itself, place endcap back on top
and replace three screws. The brush will need to
be held and centered to the cover while
placing it back on.
10. Spin the brush by hand to make sure it
turns freely with some minor resistance from
the motor. Push brush carriage back into place
with a light pull against the lock.
WARNING
To reduce the risk of electric shock, turn power switch
o and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
3.
4.
6A.
7.
9.
www.BISSELL.com
5.
6B.
8.
10.
11