Kit Assembly - Metra 99-3527 Instrucciones De Instalación

DIN radio provision with pocket
1. Remove the metal DIN sleeve from the
aftermarket radio.
2. Slide the sleeve into the radio housing
and secure by bending the metal locking
tabs down. (Figure A)
3. Slide the radio back into the sleeve until
it clicks in. (Figure B)
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio and climate controls. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
5. Reassemble the dash in reverse order of
disassembly.

KIT ASSEMBLY

(Figure A)
(Figure B)
ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and trim
ring from the aftermarket radio
2. Secure the ISO brackets to the radio
with the screws supplied with the radio.
(Figure A)
3. Slide the radio into the radio housing
until the side clips engage. (Figure B)
4. Snap the trim plate into the radio
housing. (Figure B)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio and climate controls. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
6. Reassemble the dash in reverse order of
disassembly.
(Figure A)
(Figure B)
REV. 11/20/2017 INST99-3527
3