Care And Cleaning - Kenmore 587.1520 Serie Manual De Uso

Care and Cleaning

Care and Cleaning Care and Cleaning
Care and Cleaning Care and Cleaning
Allow heating element to cool before
cleaning the interior.
Failure to do so can result in burns.
Outside
—
Occasionally wipe with a mild
nonabrasive detergent and water. Rinse and dry.
Models with Easy Care Real
Stainless Finish
warm soapy water and a dishcloth or sponge.
Rinse with clean water and a dry cloth. Do not use
harsh cleaners.
Inside
—The inside of the dishwasher is self-
cleaning with normal use. If needed, clean around
the tub gasket area with a damp cloth.
The filter is self-
cleaning. A glass
trap located in the
center of the filter
is designed to
collect pieces of
broken glass,
straws, bones and
pits. To remove
items in glass trap,
grasp handle, lift
out, empty and
replace.
Note: Hard water may cause lime deposit buildup
on the interior of the dishwasher. For cleaning
instructions see "Removing Spots and Film"
section.
Overfill Protector
overfilling and is located in the left front corner of
the tub.
• Clean occasionally with
household cleaner
containing vinegar or
bleach to dissolve any
buildup.
• Overfill Protector
should move up and
down freely about one
inch. If it does not
move, lift and clean underneath.
Burn Hazard
—
Clean outer door with
—keeps dishwasher from
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher, check to make sure it is clean so the
dishwasher will drain properly. A drain air gap is
usually mounted on countertop and can be
inspected by removing the cover. This is not part
of your dishwasher and is not covered by warranty.
Property Damage Hazard
Freezing temperatures may cause water lines
to rupture. Be sure all supply lines to and
circulating lines within dishwasher are
protected.
Failure to do so could result in property
damage.
Winterizing
A dishwasher left in an unheated place should be
protected from freezing. Have a qualified person
do the following:
To Disconnect Service:
1. Turn off electrical power to the dishwasher at
the supply source by removing fuses or tripping
circuit breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain
water into pan.
Note: See Installation Instructions for more details.
To Restore Service:
1. Reconnect the water, drain and electrical
power supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher
through a ULTIMATE SCRUB cycle.
4. Check connections to make sure they do not
leak.
Note: See Installation Instructions for more details.
19