Simpson MSV2700 Manual Del Operador página 12

DETERGENT SIPHON HOSE
1) Press chemical hose onto the barbed fitting located near the high pressure hose connection on
the pump.
2) Place other end of chemical hose with filter on it into container holding chemical/cleaning solution.
NOTE: For every 7 gallons of water pumped, one gallon on chemical/cleaning solution will be used.
3) Set your Wand to Low Pressure Setting by inserting the Black Nozzle into your Wand. See How
To use Spray Wand section in this owners manual.
4) After use of chemicals, place chemical hose into container of clean water and draw clean water
through chemical injection system to rinse thoroughly. If chemicals remain in the pump it could be
damaged. Pumps damaged due to chemicals will not be covered under warranty.
NOTE: Only use soaps and chemicals designed for pressure washer use. Do not use bleach!
NOTE: Chemicals and soaps will not siphon when Variable Spray Wand is in the High Pressure
Setting, or if the Quick Connect Spray Wand is equipped with the Red, Yellow, Green, or White
Nozzles.
Risk of property damage. NEVER pull water supply hose to move pressure washer.
This could damage the hose and/or the pump inlet.
• DO NOT use Hot water, only use cold water.
• NEVER turn water supply off while pressure washer engine is running, or damage to the pump will
occur!
• DO NOT stop spraying water for more than two minutes at a time. Pump operates in bypass mode
when spray gun trigger is not pressed. If pump is left in bypass mode for more than two minutes
internal components of the pump can be damaged.
If you do not understand these precautions, please go to www.power-washer.us
to speak to a service representative for further instructions.
Prior to starting, refer to your Engine Owners Manual for the proper starting procedure.
1) In a well ventilated outdoor area add fresh, high quality, unleaded gasoline with a pump octane
rating of 86 or higher. Do not overfill. Wipe up spilled fuel before starting engine. Refer to Engine
Owners Manual for correct procedure and fuel information.
2) Check engine oil level. See Engine Owners Manual for correct procedure.
3) Connect the water hose to the water source. Turn the water source on to
remove all air from the hose. When a steady stream of water is present, turn
the water source off.
4) Verify the filter screen is in the water inlet of the pump.
5) Connect water source to pump inlet. NOTE: Water Source must provide a
minimum of 5 gallons (18.9 liters) per minute at 20 PSI (137.9kPa).
To reduce the possibility of contamination always protect against backflow when
connected to a potable water system.
6) Connect high pressure hose to pump outlet.
7) If applying a chemical or cleaning solution, see How To Apply Chemicals/Cleaning Solvents
instructions in this manual.
8) Turn water source on.
9) Remove all air from the pump and high pressure hose by depressing trigger until a steady stream
of water is present.
10) Start engine. See Engine Owners Manual for correct procedure.
STARTING YOUR PRESSURE WASHER
12
Filter Screen