Repairs; Accessories; Troubleshooting Guide - Simpson MSV2700 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PRESSURE WASHER
1) Drain all water from high pressure hose, coil it, and store it in cradle of the pressure washer
handle.
2) Drain all water from the spray gun and wand by holding spray gun in a vertical position with nozzle
end pointing down and squeezing trigger. Store in gun holder.
3) Store chemical hose, if so equipped, so it is protected from damage.
To assure product SAFETY and RELIABILITY, repairs, maintenance, and adjustment should be per-
formed by an Authorized Warranty Service Center. Always use identical replacement parts. For the
location of the nearest Authorized Service Center go to www.power-washer.us
Recommended accessories for use with our pressure washer are available for purchase from your
local retailer or authorized service center. if you need assistance in locating any accessory for your
pressure washer, please go to www.power-washer.us
Risk of fluid injection. When using replacement lances or guns with this pressure wash-
er, DO NOT use a lance and/or lance/gun combination that is shorter in
length than what was provided with this pressure washer as measured from the
nozzle end of the lance to the gun trigger.
The use of any other accessory not recommended for use with this tool could be haz-
ardous. use only accessories rated equal to or greater than the rating of the pressure washer.
PROBLEM
Engine will not
start (see Engine
manual for further
troubleshooting).

REPAIRS

ACCESSORIES

TROUBLESHOOTING GUIDE

CAUSE
No Fuel
Pressure builds up after two
pulls on the recoil starter or
after initial use.
Choke level in the "No Choke"
position.
Spark plug wire not attached.
Engine Switch in the "OFF"
Position.
Choke lever in the "CHOKE"
position on a "hot" engine
or an engine that has been
exposed to thermal heat for a
long period of time.
CORRECTION
Add fuel.
Squeeze gun trigger to relieve pressure.
Move choke to the "CHOKE" position.
Attach spark plug wire.
Place engine switch in "ON" Position.
Move choke to the "NO CHOKE" position.
15

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido