Kit Assembly - Metra 95-5820 Instrucciones De Instalación

1. Ensure the notch in the radio housing
is directed upwards. Attach the radio
brackets to the housing by aligning
the holes in the housing with the radio
brackets, then rotate inward. (Figure A)
2. Slide the radio into the bracket/housing
assembly, then secure using the screws
supplied with the radio. (Figure B)
3. Cut off and remove the top (2) mounting
legs from the radio housing. (Figure C)
4. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Complete
all connections to the radio and vehicle,
then test the radio and vehicle for
proper operation.
5. Slide the completed radio assembly into
the dash and secure using the factory
screws.
6. Reassemble the dash in reverse order
of disassembly using the 95-5820 radio
trim panel to complete the installation.

KIT ASSEMBLY

(Figure A)
(Figure B)
CUT HERE - TOP LEG ONLY
CUT HERE
CUT
(Figure C)
REV. 4/8/2019 INST95-5820
TOP LEG ONLY
CUT
5