Bell BICYCLE CHILD CARRIER Manual De Instrucciones página 10

STEP 25
Grab the straps and pull on them to confirm that the
harness is properly anchored to the seat in both the
upper locations as well as the center lower location.
STEP 26
Push the grab bar into the holes in the seat. The grab
bar can be removed by pinching the tabs together
and pushing upward.
STEP 27
Peel the backing off the adhesive tape and adhere
the reflector to the untextured area of the back of the
seat. Press firmly in position.
STEP 28
Double check to make sure that all of the fasteners
are securely tightened.
CONGRATULATIONS!
This completes the assembly and installation of the
Child Carrier.