Dri-Eaz DrizAir 1200 El Manual Del Propietario página 4

Ocultar thumbs Ver también para DrizAir 1200:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IIlustration of Touchpad
07-01486 A 04-04 Copyright 2004 Dri-Eaz Products, Inc.
READ AND SAVE THESE INSTRUCTIONS
H
OW TO
The Touchpad on DrizAir dehumidifiers has one display and four keys. The
normal display messages are:
When you first plug in the unit, the touchpad display will cycle contin-
uously through three messages: DEHUMIDIFER OFF, TOTAL
HOURS, and JOB HOURS.
U
T
SE THE
OUCHPAD
DEHUMIDIFIER OFF
DEHUMIDIFIER ON
TOTAL HRS
JOB HRS
ON-OFF. Press the ON-OFF key to turn the unit on or off. When
turning the machine on, usually the display reads CMPRSR
DELAY and performs a numeral count down from a maximum of
60 seconds to 0. The compressor delay gives the machine time to
warm up (when needed). If you don't see a compressor delay
countdown, the machine is ready to go. Once the unit completes
the CMPRSR DELAY, the display reads DEHUMIDIFIER ON, and
continues to cycle between TOTAL HOURS, JOB HOURS and
DEHUMIDIFIER ON.
Press the ON-OFF key again to turn the unit off. The display will
read DEHUMIDIFIER OFF.
DISPLAY. Press the DISPLAY key to stop the display at DEHUMID-
IFER ON or OFF, TOTAL HOURS, or JOB HOURS as it cycles.
Press DISPLAY again to re-start the display cycle.
How to change the language display
While in the change-language mode, pressing other keys can
change the programming of the machine. Do NOT press other
keys you're not instructed to press.
Use the DISPLAY key to change the display language.
Follow these steps:
1. Start with the unit unplugged.
2. While holding down the DISPLAY key, plug the unit in.
The display reads ENGLISH.
3. To change to FRANCAIS, DEUTSCH, or ESPANOL,
press the DISPLAY key or the CLEAR key.
4. When the desired language is shown in the display,
unplug the unit, and the language is set.
CLEAR.
ress the CLEAR key to reset the JOB HOURS:
P
1. As the display cycles between DEHUMIDIFIER ON, JOB
HOURS, OR TOTAL HOURS, press the DISPLAY key
when JOB HOURS appears on the screen. That will
make the display read JOB HOURS steadily.
2. Then press the CLEAR key to re-set the numerals to
00000.
3. Press DISPLAY again to re-start the display cycle.
the TOTAL HOURS reading cannot be re-set.
NOTE:
C
K
ONTROL
EYS
CMPRSR DELAY
PUMP PURGING
DEFROST ON
GET SERVICE ERO1
CAUTION
4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Drizair 2000Drizair 2400

Tabla de contenido