Publicidad
Idiomas disponibles
Idiomas disponibles
EcoSystem
Step 2: Mains Voltage Wiring
The EcoSystem Bus Supply operates at 100-277 V
Use the following instructions to properly wire line voltage
to the EcoSystem Bus Supply.
DO NOT WIRE LIVE! Interrupt power via circuit
breaker before wiring or servicing the EcoSystem
Bus Supply.
A. Use #12 to #18 AWG (2.5 to 1.0 mm
mains wiring (100-277 V
120 mA.
B. Wire mains to the black terminals labeled N and H/L.
Four terminals are provided, two for Neutral (N) and two
for Hot/Live (H/L). Redundant terminals provide for easy
wiring of mains to other modules if needed.
C. The EcoSystem Bus Supply is grounded via the DIN rail
through clips on the bottom of the module. Attach ground
wire to DIN rail via the green terminal block (provided on
WM version only) or to DIN rail mounting screw.
D. Turn on circuit breaker to energize the EcoSystem Bus
Supply. V
PWR indicator on the EcoSystem Bus
Supply will light green when properly energized. If the
indicator does not light, verify line voltage wiring.
Emergency Lighting: When the power to the EcoSystem
Bus Supply is removed, the EcoSystem Bus Supply signals
to ballasts and modules powered by emergency/essential
power to go to their programmed emergency light level
(100% by default). For this reason, the EcoSystem Bus
Supply should not be powered via an emergency/essential
lighting circuit.
Note: If additional wiring space is necessary, the
EcoSystem Bus Supply can be removed from the DIN rail
while wiring. Follow the instructions in Step 1: EcoSystem
Bus Supply and Enclosure Mounting for details.
EcoSystem
Bus Supply Installation Guide
TM
| Bus Supply Installation Guide
TM
) conductors to feed
2
). The device draws less than
.
Earth/Ground
Mains Wiring to EcoSystem Bus Supply
(CS-1L-WM shown)
H/L H/L N N
E2
E2
DIN Rail Clip
Front View of EcoSystem Bus Supply
(CS-2L version shown)
H/L H/L N N
Mains Wiring Input
LUTRON
®
V PWR indicator lights
when powered
E1
E1
E1
E1
E2
E2
H/L: Hot/Live
N: Neutral
Lutron |
Publicidad
