Conformity Declaration - Rupes LE21A Instrucciones De Uso Y Manutención

TOOL IDENTIFICATION PLATE
POSITION AND MEANING OF INFORMATION
1. Type of tool.
2. Nominal working voltage in Volts (V).
3. Working frequency in Hertz (Hz).
4. Absorbed current in Amperes (A). Ensure that the power supply to
which the tool is connected can easily tolerate the indicated
current as a minimum.
5. Absorbed power expressed in Watts (W).
6. Tool code or serial number.
7. Technical data of the tool.
8. Maximum rpm
9. The double square indicates that the tool is doubly insulated and
therefore does not require earthing through the power supply
cable.
10. Read all these instructions before operating this product and
save these instructions.
11. Personal safety devices.
12. At the end of its useful life, the product, pursuant to European
Directive 2002/96/CE (RAEE) + 2003/108/CE and its
implementation in national law, must not be released into the
environment or thrown away as domestic waste, but must be
disposed of at authorised recycling centres (contact the relevant
local authorities for a list of places where the product may be
disposed of according to the law).Disposing of the product
correctly contributes to protecting human health and
safeguarding the environment. Any illegitimate disposal of the
product will be punishable by law.

CONFORMITY DECLARATION

We declare on our responsability that the hand-held motor operated tool,
which is mentioned in the present operating manual, is in comformity with
the Essential Requirements of Safety of the following Directives:
2006/42/CE Machinery
2006/95/CE Low Tension
2004/108/CE Electromagnetic Compatibility
The tests have been carried out in accordance with following Standards:
EN ISO 12100: 2010 Safety of machinery – General principles for
design – Risk assessment and risk reduction
EN 60745-1:2008 Safety of hand-held electric motor operated tools
EN 60745-2-4: 2003 Particular requirements for sanders
UNI EN ISO 3744:1997 Acoustics. Determination of sound power levels
of noise sources.
UNI EN ISO 11202: 1997 Acoustics. Noise emitted by machinery and
equipment.
UNI EN 28662-1: 1993 Hand-held portable power tools. Measurement of
vibrations at the handle.
UNI EN ISO 5349-1: 2004 Mechanical vibration. Measurement and
evaluation of human exposure to hand-
transmitted vibration.
Electromagnetic compatibility:
EN 55014-1: 2008 + EN 55014-2: 1998
EN 61000-3-2: 2009 + EN61000-3-3: 2008
Electromagnetic fields:
EN 62233: 2008
S.p.A
IL PRESIDENTE
G. Valentini
11