Spare Parts - Notch ROPE RUNNER PRO Manual Del Usuario

11 \ SPARE PARTS

Stainless Steel Slic Pin Upper Adjustment Bollard
#54444
14
Lower Bollard
#54110 #54115
Friction Body Kit
#54120
EN
INTRODUCTION
These instructions explain the correct usage of the equip-
ment. Only certain techniques and uses are described. The
user must always have a solid understanding and working
knowledge of rope based climbing techniques and the
ability to judge safety risks.
Please review all warning symbols.
The user is solely responsible for heeding all warnings
and using the equipment correctly. Any misuse of this
equipment will create additional danger. Contact Notch
Equipment if you have any doubts or difficulty
understanding these instructions.
1 \ FIELD OF APPLICATION
Personal protective equipment (PPE) used for fall
protection.
Maximum working load: 140kg (309 lb.)
Rope Runner Pro: A progression friction rope device for
tree care on a single rope (SRS = Stationary Rope System)
or doubled rope (MRS = Moving Rope System). (Fig 1A & 1B)
This product must not be used for any other purpose
other than for which it is designed.
Stationary Rope System (SRS) – The Rope Runner Pro
can be used to ascend, descend and hold a position on
a single strand of rope without the need for additional
friction.
Moving Rope System (MRS) - The Rope Runner Pro can
also be used to ascend, descend and hold a position on
one rope doubled over an anchor point and connected
back to the user's harness.
Responsibility / WARNING
Activities involving the use of this equipment are inher-
ently dangerous. The user is solely responsible for their
actions and decisions.
Before using this equipment, you must:
• Read and understand all instructions for use.
• Understand, accept, and assume all risks and responsi-
bilities for all damage, injury, or death that may result
from use of this equipment.
• Obtain the necessary training from a qualified and
competent instructor in its proper use.
• Fully understand and accept its capabilities and
limitations.
Failure to follow any of these warnings may
result in severe injury or death.
If you are incapable of following these instructions, do
not use this equipment.
Working at height is a very dangerous activity which may
lead to severe injury or fatality. You must personally
assume the responsibility to learn the use and the safety
measures that apply to this equipment. Remember that
there is no better instruction than that of a trained
instructor. Train in the use of this equipment, verify that
you have fully understood how it works, and if in any
doubt, please ask a competent person! Don't make any
alterations or additions to the equipment without the
manufacturer's prior written consent. Any repair shall only
be made by the manufacturer. The product shall not be
used outside its limitations or for any purpose other than
that for which it is intended.
2 \ NOMENCLATURE
(1) Stainless Steel Slic Pin, (2) The Bird, (3) Upper Adjust-
ment Bollard, (4) Friction Adjustment Settings, (5) Lever,
(6) Lower Bollard, (7) SRS Ascent Attachment Point,
(8) Lever Lock Arm, (9) Aluminum Slic Pin, (10) Pulley,
(11) Friction Body, (12) Main Attachment Point,
(13) Lubrication Port.
Principal Materials: Aluminum alloy, stainless steel
15