Escalade Sports prince SPORT T8830 Instrucciones De Ensamblaje página 8

HARDWARE NEEDED
29
1/4-20 x 1 ¾" Hex Head Bolt
(Qty. 1)
1/4-20 x 2 ¾" Hex Head Bolt
(Qty. 2)
10. Attach safety strap #6 to linkage #4. Be sure to attach on the end of
linkage with TWO holes. Use one bolt #9, one washer #24, one
Spacer #30, and one hex nut #15. See Detail H1.
11. Attach end of linkage #4 with the attached Safety Strap #6 INSIDE of
U-Leg #2 as shown in Detail H2. Secure through end hole with bolt
#23, Spacer #31 and locknut #15. Tighten hardware snug enough to
keep table stable but do not overtighten. Tubes must pivot freely.
12. Attach slotted end of safety strap #6 to INSIDE of Leg #2
using one bolt #29, one spacer #30, one washer #24, and
one hex nut #15. Tighten hardware until snug but do not
overtighten. Tubes must pivot freely. See Detail H2.
13. Attach linkage #4 INSIDE other end of U-Leg #2 as
shown in Detail G. Secure through end hole with bolt
#23, plastic spacers #31 and locknuts #15. Tighten
hardware snug enough to keep table stable but do not
overtighten. Tubes must pivot freely.
9
Detail H1
3/4" Spacer
15
31
(Qty. 2)
1/4" Locknut
(Qty. 3)
5/16" Spacer
30
(Qty. 2)
24 6
4
30
15
24
4
9
2
First Table Top
Figure 5A
Important! Do NOT put other
safety strap #6 on this table
half. It will be installed on
second table half later.
2
30
29
31
(Longer)
23
(Longer)
Detail H2
8
HARDWARE NEEDED
Plastic Washer
(Qty. 2)
1/4-20 x 1 1/2 Bolt
(Qty. 1)
Note: This is the end of the
table with no rails.
24
15
15
4
4
31
15
Detail G
7
4
2
23