BARREL REST ASSEMBLY
Assemble the barrel rests to the back and sides of the cabinet with (2) type "B"
screws each as shown.
B
1/2" Screw
read the screws into the pilot holes from the outside of the cabinet. Align
the holes of the barrel rest over the tips of the screws and lightly press the
barrel rest into place. Now tighten the screws from the outside of the cabinet.
Tighten each screw partially, alternating from one screw to the other until
they are both tight. Do not over tighten or you may damage the barrel rest.
B
If you have chosen a con guration with half guns and half storage, you only
need to install the barrel rests on one side of the cabinet unless you want to use
the barrel rest that extend beyond the shelving.
B
SHELF ASSEMBLY
e shelves can be mounted at 3 locations in the le and right compartments
and 6 positions in the center compartment. NOTE: if the rear brackets are
mounted to the back wall in the center compartment the shelves can not be
installed in the center section.
Mount the shelves with the side edges facing down. You have the option of
having the front edges facing up or down.
Assemble each shelf with (4) type "A" nuts and bolts. Hand tighten only until
all the shelves are in place.
When all the shelves are in place, tighten all nuts and bolts including
those in the top shelf.
A
5
27
40350-1309