Adjusting The Stops On The Dsmi - Festo DSMI-B Serie Instrucciones De Utilizacion

DSMI−...−B
To fasten the work load:
1. Push the moving mass on to the drive shaft.
2. Make sure that the moving mass cannot
slide off the drive shaft. This is ensured by
the thread in the drive shaft. When
tightening the screws, lock them at the
hexagon socket 9.
DSMI−...−B
Tightening torque
Fig. 7
· Adjust the stops of the end positions statically according to the type.
· If possible, use symmetric angle settings
that follow the line of symmetry of the
DSMI.
These produce a more even movement
between right−hand and left−hand swivel
ing movements.

Adjusting the stops on the DSMI

Note
Operating the DSMI without cushioning will destroy it.
· Make sure that the DSMI is always only operated with shock absorbers
(electronically controlled, internal or external).
· Make sure that the locking screws aB of the shock absorber retainers are
retightened with the specified tightening torque.
· Observe the instructions in the descriptions of the positioning controller
when adjusting the stops.
For use as a measuring cylinder:
· Replace the adjustment sleeves with cushioning elements
(elastomer shock absorbers or shock absorbers è Accessories" chapter).
Observe the enclosed documentation.
Festo DSMI−...−B 1003a English
Fig. 6
25
[Nm] 2.9
Fig. 8
40 63
9.9 47
29