Publicidad
CARLO GAVAZZI
A u t o m a t i o n C o m p o n e n t s
Page 7 (110)
NOTE
140 OPTICAL: this function allows the user to set the communication
mode of the front optical port.
150 RS232-485: This function allows the user to set the RS232 and RS485
serial communication ports (MC232485 module).
160 ETHERNET: This function allows the user to set the Ethernet commu-
nication port. In case of BACnet IP port, the BACnet instance number can
only be programmed by WM3040Soft programming software.
170 BACNET 485: This function allows the user to set the BACnet MS/TP
parameters. The BACnet instance number can only be programmed by
WM3040Soft programming software.
180 VIRT AL 1: This function allows you to set the alarm parameters. 181
ENABLE: enable (YES) or disable (NO) the alarm. 182 VARIABLES: set the
variable to be linked to the alarm. 183 SET 1:set the on alarm set point of
P P R R O O G G R R A A M M M M I I N N G G W
W M M 4 4 0 0 - - 9 9 6 6
Page 12 (350)
the variable. 184 SET 2: set the off alarm set point of the variable. 185 ON
DELAY: set a delay on activation of the alarm.
Some specific menus display only if the relevant modules are
installed.
List of available
variables
As VIRT
AL1
As VIRT
AL1
As VIRT AL1
12
Key-pad
Push for at
least 2 s
Publicidad
