Expert E2005II Manual Del Usuario página 4

RADIATOR PRESSURE TESTER KIT
1. Carefully unscrew and remove the
radiator cap using a damp cloth or
gloves and arm protection if the
radiator cap is known to be hot.
2. Select the correct adaptor or
configuration of the adjustable
clamping cap and accessories, it is
securely fi tted to the fi ller neck of the
radiator or expansion tank.
3. Attach the "push-fi t" connector onto
the male tailpiece of the adaptor
assembly fi tted to the radiator.
4. Pump the hand pump plunger and
check the reading indicated on the
gauge. Ideal readings should range
between 12-15PSI (refer to the
manufacturer's workshop manual
for the specifi c parameters of the
vehicle being tested), if the pressure
level is below the specifi c range, this
indicates that there is a leak in the
radiator or a hose that is contributing
to the problem with the vehicle.
5. Once the test is complete, release
the air pressure by pressing
pressure release valve, disconnect
the "push-fi t" connector and remove
the adaptor assembly.
Instructions
I M P O R TA N T: P L E A S E
INSTRUCTIONS FULLY AND CAREFULLY TO
ENSURE THE SAFE AND EFFECTIVE USE OF
THIS TOOL.
HAND OPERATED PRESSURE PUMP
IMPORTANT: These instructions must be used in
conjunction with the vehicle manufacturer's workshop
manual which will contain detailed and concise
directives for the correct use of this kit.
Pressure release valve
"Push-fi t" connector
"Push-fi t" connector
HAND OPERATED PRESSURE PUMP
Includes pressure release valve to release
pressure build up after testing, before
removing the adaptor from the radiator
neck.
R E A D T H E S E