Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove the fascia door, if present.
3. Raise the hitch into position; lifting the bumper mounting bracket over
the fascia (where needed). Secure with M12 bolts and conical washers into
the existing weld nuts, being careful not to push the bolts into the frame, as
shown Figure 1.
©2016 Cequent™ Performance Products, Inc. -
2. Feed the carriage bolt and large block thru slots on bottom of frame rails using
the pull wire, as shown Figure 3
Printed in Mexico
4. Feed conical washer over pull wire, using the
washer to hold the bolt in place remove the pull wires
and attach the hex nut. Hand tighten all bolts.
Sheet 4 of 15
76028NP
3-30-16
Rev. A
Publicidad
