Publicidad
Idiomas disponibles
Idiomas disponibles
1a. Remove bumper fascia – Use 7 mm socket and T15 driver to remove (4) screws at bottom
1b. Open the trunk and gently pull the fascia away from the car. Disconnect electrical connector on
center of fascia, (6) screws beneath splash board and on the side of heat shield (each
the driver side before completing fascia removal.
side), and (3) screws inside wheel well (each side).
2. Use 15mm socket to remove (2) flange nuts on each side of rear exhaust hanger bracket
3. Use flat head screwdriver to remove (10) nuts attached on heat shield. Trim the heat
and take off the bracket. Then remove (3) places rubber exhaust hangers separately.
shield as shown in Figure 2 and to be reinstalled after trimming.
6''
2.5''
4''
5''
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
Sheet 4 of 15
24927NP
06-08-16
Rev. D
Publicidad
