Publicidad
Idiomas disponibles
Idiomas disponibles
4. Raise hitch into position and align forward mounting hole with hole on the frame. Using
hitch as a template, mark and drill a rear mounting hole (17/32'') on both sides of the
frame. Make sure the hitch is secure before drilling.
6. Raise hitch into position again and feed the pull wires previously installed through holes
on the bracket. Remove pull wires and loosely install conical washer ③ and hex nut ④
to the hitch.
7. Tighten all ½'' GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
5. Feed the carriage bolt ① and spacer ② through slots on bottom of frame rails using the pull
wires ⑤, as shown in Figure 3. Leave pull wires attached.
8. Reinstall exhaust hangers, exhaust hanger brackets, fascia, and all fasteners removed in
Step 1, 2.
CEQUENT
Sheet 5 of 15
24927NP
06-08-16
Rev. D
Publicidad
