Brigmton BAI-300 Manual De Usuario página 18

1. Place the headphones onto the cradle as shown below. The charging
contacts (16) of the transmitter cradle must touch the charging contacts
of the headphones (7).
The power and charge indicator (18) of the transmitter cradle will light
up orange while the battery is charging. When the charging process is
completed, the power and charge indicator will light up green.
If you place the headphones onto the transmitter cradle while they are
switched on, they will be switched off automatically.
POWERING THE HEADPHONES ON/OFF
If the battery level of the headphones is high enough (the power and
charge indicator (12) on the transmitter must be green), you may
remove the headphones from the transmitter cradle.
You may optionally power the headphones using conventional batteries.
For more information, see the information on page 12 – Battery
Operation.
1. Press the On/Off button (10) of the headphones once to switch them
on. The power indicator (8) will light up orange.
2. Press the On/Off button of the headphones again to switch them off.
The power indicator then goes out.
Please remember to set the correct position for the Power source
DC1/DC2 selection switch (9). When set at DC2 position, the device will
power on only if charged batteries have been inserted into the
headphones. Please also see page 12 - Powering the Headphones by
Using Batteries.