Brigmton BAI-300 Manual De Usuario página 19

SELECTING THE OPERATING MODE
1. Slide the mode selection switch (4) to the "WL" position to use the
wireless headphones to listen to an external audio source (e.g. your hi-fi
equipment).
2. Slide the mode selection switch (4) to the "FM" position to receive
your favourite FM radio programmes.
After powering on, the send indicator (17) lights up orange. This
indicates that the transmitter cradle is attempting to establish a
connection with the headphones.
Synchronising the transmitter cradle and the headphones can take a
while.
POWERING THE TRANSMITTER CRADLE ON
1. To power the transmitter cradle on, slide the On/Off switch to the
"ON" (position 1 is 863.5M, position 2 is 864M, position 3 is 864.5M),
and position 2 (864M) is the Default frequency of headphone.
POWERING THE TRANSMITTER CRADLE OFF
You may power the transmitter cradle off whenever it is not needed.
When powered off, it will not transmit any RF signals but the headphones
battery will still be charged.
1. Slide the On/Off switch (14) on the transmitter cradle to the "OFF"
position. The send indicator (17) on the transmitter goes out. You may
optionally power the transmitter cradle using conventional batteries.
ADJUSTING THE VOLUME
1. Press the VOL+ button (1) once or several times to increase the sound
volume.
2. Press the VOL- button (3) once or several times to decrease the sound
volume. If you have connected your headphones to an external audio
source, you may also adjust the volume directly on the audio source
(e.g. by using the remote control of your hi-fi equipment). However,
please remember that many audio devices provide a constant signal level
on their Cinch audio outputs, thus not allowing a volume adjustment
when using this type of connection.
USING THE HEADPHONES WITH A CABLE
If your location is close to the audio source and you don't wish to make
portable use of your headphones, you may use them with a normal cable