Brigmton BAI-300 Manual De Usuario página 22

2. Open the battery compartment by sliding the lock of the compartment
cover into the direction of the compartment. The cover can be opened
and then removed.
3. Insert three AAA batteries into the battery compartment. Note the +
and – icons on the batteries and inside the battery compartment.
4. Place the battery compartment cover over the battery compartment
so that the locking nose of the cover is inserted into the corresponding
notch on the transmitter cradle. Then close the battery compartment
cover until it locks in place.
While the transmitter cradle is on battery power, it will not charge the
built-in headphone battery.
If you have inserted batteries into the transmitter cradle and you
connect the power adapter to the power socket (12), battery operation
will be disabled automatically. This helps you to save battery power
whenever the device is connected to the mains via the power adapter.
APPENDIX
TROUBLESHOOTING
You can solve most common problems yourself by using the following
hints. If the problem persists after checking the suggested solutions,
please contact our company (see gift box). Do not attempt to repair the
product yourself.
The headphones do not power on, there are no indicator lights.
*Recharge the built-in battery or insert conventional batteries.
*Check the position of the function switch (9). For conventional battery
operation it must be set to the "DC2" position: for operation from the
internal rechargeable battery it must be set to "DC1".
The headphones power on but there is no sound output.
*Check that the transmitter cradle has been powered on and connected
properly to your audio source. Start playback on the sound source.
Unable to power the transmitter cradle on.
*Did you connect the power adapter or are the inserted batteries
sufficiently charged?
Sound is interrupted or noisy.
*The rechargeable battery or the inserted batteries of the headphones
are depleted. Recharge the internal battery or replace the batteries with
new batteries of the same type.
*You are outside the maximum range of the transmitter. Move closer to
the transmitter cradle.