Storage And Ventilation; Assembly; Preparations; Table Of Components - Lanberg WF01 64 V2 Manual De Instrucciones

1.9 Storage and ventilation

• The product should be installed only in locations with limited access (separate rooms for equipment, etc.).
• Do not install and store the device in places with water (still or running), humidity, or any other liquid substances being present.
• Avoid exposing the product to direct sunlight sources.
• Place the device on a stable, dry surface in a well-ventilated place. Leave at least 100 mm of free space around it to ensure
adequate ventilation.
• The device is designed to work only in a controlled environment (controlled temperature and humidity according to the data in the
specification, indoors, without conductive pollution present [dust, flammable gases, corrosive substances, etc.]).

2. Assembly

i
Be sure to strictly follow the instructions in this manual.

2.1 Preparations

Prepare the appropriate amount of free space on the surface on which the assembly will take place. Carefully remove all elements from
the transport box. Further assembly instructions will be based on the diagram provided. Prepare 4 mounting anchors and 4 screws (not
included) matching the load capacity of the cabinet's overall weight. Those elements also have to fit the diameter of the wall-mount rail's
installation holes: 4 – Ø 10.
Due to the use of M6*12 Phillips screws to attach the top and bottom covers with side frames, we recommend a good Phillips screwdriver.
The recommended specification is PH3x150 mm.

2.1.1. Table of components

Component
Front glass / metal door with 2 grounding pins
Side frame with attached side panel equipped with 2 latches
Top cover with cable entry and 2 holes in the middle for 12x12 cm fans
Flat blank panel for top and bottom cable entry panel
Rear cabinet cover
Vertical mounting rails with "U" numbered height
Wall-mount rail
M4*8 Self-tapping Phillips screw
M5*8 Self-tapping Phillips screw
M6*12 Phillips screw
M6*12 Phillips screw with M6 Cage Nut
Plastic washer to be installed under the front door
Grounding kit (wire, washers, nuts)
Front door lock with keys and a flat metal latch
Side door lock with keys and a curved metal latch
Bottom cover with cable entry and 4 holes with M10 threaded nut on the sides and 2 grounding pins
16
M4*8 Self-tapping
Phillips screw
Element
I
Illustration
Supplied quantity 16x
Lanberg © 2015-2021
Supplied quantity
< 10 U: 12x
M5*8 Self-tapping
M6*12 Phillips screw
Phillips screw
J K
8x 8x
Component symbol
1x A
B
2x
C
1x D
2x E
1x F
4x G
1x H
16x I
8x J
8x K
>= 10U: 24x L
1x N
1x M
1x O
2x P
1x R
M6*12 Phillips screw with
M6 Cage Nut
L
< 10 U: 12x >= 10U: 24x
EN