Side Door Lock Installation; Vertical Mounting Rails Installation - Lanberg WF01 64 V2 Manual De Instrucciones

2.2.2. Side door lock installation

1. Remove the side door from the side frames [B + C]. Their
reassembly will take place during the final assembly of the
cabinet.
2. Insert the lock module from the string bag marked with [P]
symbol through the door so that 2 parallel flat parts of the
module are in a horizontal position. The next steps will be for
other elements included in this bag.
i
Use the keys to set the lock in a horizontal position.
3. Screw the washer in by inserting it with engraved triangles
side towards the door onto the lock module. Finally, hold
the lock module with the door keys and try to tighten the
washer tightly.
4. Apply the curved metal lock latch horizontally (curved part
facing the door) to the square module element with the screw
hole. Next, insert the flat metal round washer and then star-
shaped one. Fix everything together by screwing the bolt into
the lock module.
5. The same steps 1 ~ 4 should be performed for the 2nd
side door [C].

2.2.3. Vertical mounting rails installation

Before further installation, pay attention to where the front
i
and rear sides of the side frames [B + C] are.
1. Place on a flat surface both side frames [B + C] (without the
doors) so that their fronts face your direction.
The distance between the centres of the small holes in the
side frames [B + C] is 25 mm.
The maximum distance (working depth) between the front
and rear vertical mounting rails (taking into account their
thickness) is:
I) For wall-mounted enclosures with a total length of 450
mm: 379.5 mm.
II) For wall-mounted enclosures with an overall length of
600 mm: 529.5 mm.
However, it is recommended to install the rear vertical
mounting rails on the 3rd hole from the end (50 mm
difference) on the side frames to accommodate the devices
with the input plug and cable (approx. 55 mm on average).
2. Use 2 vertical mounting rails [G] and adjust the required
distance between them on the left side frame [B].
It is vital to make sure that the numbering of the front
i
vertical rails is in ascending order from right to left (see the
provided illustrations). Rear vertical rails also have to be
mounted the same way.
3. Use a total of 4 M5*8 self-tapping Phillips screws [J] to attach
the vertical mounting rails to the side frame - 2 screws for each
end of the rail.
18
Back
Front
Lanberg © 2015-2021
P
x4
EN