General Description - Cole-Parmer Stuart SBS40 Manual De Instrucciones

SHAKING WATER BATH
SBS40
1. Introduction
Thank you for purchasing this piece of Stuart
equipment. To get the best performance from
the equipment please read these instructions
carefully before use.
Before discarding the packaging check that all
parts are present and correct.
For your own safety and that of others
please read and understand the safety
advice given below before using the
equipment.

2. General Description

The Stuart SBS40 shaking water bath is the ideal
instrument for mixing, gently heating and
aerating biological and chemical samples in the
laboratory. The unique design allows a choice of
either linear or orbital mixing action, depending
on the application. Both platforms will
accommodate up to 15 springs, which will hold
almost any size and combination of flasks,
bottles or beakers. Max load for both platforms
is 10kg.
3. Safety Advice before use
If the equipment is not used in the manner
described in this manual and with
accessories other than those recommended by
Cole-Parmer the protection provided might be
impaired.
This equipment is designed to operate under the
following conditions: -
❖ For indoor use only
❖ Use in a well ventilated area
❖ Ambient temperature range +5°C to +40°C
❖ Altitude to 2000m
❖ Relative humidity not exceeding 80%
❖ Mains supply fluctuation not exceeding 10%
❖ Over-voltage category II IEC60364-4-443
❖ Pollution degree 2
❖ Use with a minimum distance all around of
200mm from walls or other items
❖ DO NOT mix combustible liquids or use the
equipment in hazardous atmospheres.
❖ When empty the unit should be carried using
both hands.
❖ The unit is designed for use with aqueous
liquids. It may be dangerous to use other
liquids (especially inflammable substances) in
the bath.
❖ Do not attempt to stop movement by hand.
❖ Never move or carry the unit when in use or
connected to the mains electricity supply.
❖ In the case of mains interruption, the unit will
not restart on restoration of the electricity
supply.
❖ In the case of mechanical interruption, (e.g.
motor stall), the unit will continue operating
on removal of interruption.
❖ Mechanical energy can lead to breakage of
glass vessels. Use with care.
❖ DO NOT position the product so that it is
difficult to access the ON/OFF switch.
❖ DO NOT position the product so that it is
difficult to disconnect it from the mains
supply using the mains plug.
❖ The mains outlet socket used should be
located close to the equipment and readily
identifiable and accessible to users.
Never move or carry the unit when filled
with water.
1