Chromatherapy Operation (If Equipped); Care And Cleaning - Kohler K-712 Guía De Propietario

Operating Your Bath with Airjets (cont.)
Observe that, about 1 minute after shutdown, all user keypad lights turn off.
Initiating a Manual Purge Cycle
After stopping the air system and draining the bath, rotate the ring on the user keypad to the purge
icon.
Observe that the purge cycle icon is flashing blue.
Press the "OK" button once.
The purge icon flashes green and the mode is implemented. The air system operates at a low speed
to blow any residual water out of the air harness.
After about 2 minutes, the air system stops automatically.

Chromatherapy Operation (if Equipped)

NOTE: Chromatherapy may be used with all modes of operation. Chromatherapy may also be used when
the air system is not operating.
Chromatherapy Cycle - When you activate this mode, the chromatherapy lights automatically and
continuously cycle through the eight colors: white, violet, indigo blue, aqua blue, green, yellow,
orange, and red. One cycle through all eight colors takes about 1 minute. Rotate the outer ring to
select this mode and press "OK" to activate it. To turn off the lights, press the "OK" button while
the chromatherapy mode is selected and active.
Chromatherapy Specific Color Selection - Activate this mode to choose a specific color for your
bath. Rotate the outer ring to select this mode, press the "OK" button, and use the up and down
buttons to select the desired color. To turn off the lights, press the "OK" button while the
chromatherapy mode is selected and active.

Care and Cleaning

For best results, keep the following in mind when caring for your KOHLER bath with airjets:
• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry any overspray that lands on nearby surfaces.
• Do not allow cleaners to soak on surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring
pad to clean surfaces.
• The ideal cleaning technique is to rinse thoroughly and blot dry any water from the surface after
each use.
• Use a soft nylon brush on slip-resistant surfaces. Be sure to use a water-soluble cleaner (dissolves
100% in water).
• Do not use powdered cleaners unless the cleaner is fully dissolved in water. Solid substances can
block the airjets.
• Do not use full strength bleach or ammonia cleaning solutions. Chemically active cleaning
solutions can damage the surface.
• Do not use abrasive cleansers or solvents on airjet surfaces. Abrasive cleaners and solvents can
damage the airjet surface.
Maintaining the Airjets
If cleaning the airjets is necessary due to hard water deposits, wet a soft, non-abrasive cloth with
white vinegar and wipe the plugged airjet holes. Immediately rinse the area with clean water to
avoid long-term exposure of the vinegar to the airjet surface.
Fill the bath with water to the top row of airjets. Drain the bath and press the purge button.
Cleaning Your User Keypad and Remote Control
1146920-5-B 8 Kohler Co.