Chromatherapy Operation (If Equipped); Care And Cleaning - Kohler K-1167 Guía De Propietario

Operating Your Bath with Airjets (cont.)
Observe that, about 1 minute after shutdown, all user keypad lights turn off.
Initiating a Manual Purge Cycle
After stopping the air system and draining the bath, rotate the ring on the user keypad to the purge
icon.
Observe that the purge cycle icon is flashing blue.
Press the "OK" button once.
The purge icon flashes green and the mode is implemented. The air system operates at a low speed
to blow any residual water out of the air harness.
After about 2 minutes, the air system stops automatically.

Chromatherapy Operation (if Equipped)

NOTE: Chromatherapy may be used with all modes of operation. Chromatherapy may also be used when
the air system is not operating.
Chromatherapy Cycle - When you activate this mode, the chromatherapy lights automatically and
continuously cycle through the eight colors: white, violet, indigo blue, aqua blue, green, yellow,
orange, and red. One cycle through all eight colors takes about 1 minute. Rotate the outer ring to
select this mode and press "OK" to activate it. To turn off the lights, press the "OK" button while
the chromatherapy mode is selected and active.
Chromatherapy Specific Color Selection - Activate this mode to choose a specific color for your
bath. Rotate the outer ring to select this mode, press the "OK" button, and use the up and down
buttons to select the desired color. To turn off the lights, press the "OK" button while the
chromatherapy mode is selected and active.

Care and Cleaning

Do not use powdered cleaners unless the cleaner is fully dissolved in water. Solid substances
could block the airjets.
Do not use full strength bleach or ammonia cleaning solutions. Chemically active cleaning
solutions can damage the bath surface.
Do not use abrasive cleansers or solvents on acrylic surfaces. Abrasive cleaners and solvents can
damage the bath surface.
Wipe out your acrylic bath with a soft cloth after each use.
Avoid detergents, disinfectants, or cleaning products in aerosol cans.
NOTE: To restore dull or scratched units: Apply white automotive polishing compound with a clean rag.
Rub scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste
wax. Do not wax areas where you walk or stand.
Cleaning Your User Keypad and Remote Control
Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes dirty,
use a non-abrasive soap and warm water to clean.
Maintaining the Airjets
If cleaning the airjets is required due to hard water deposits, use a small between-the-teeth dental
brush and white vinegar. Dip the brush in the vinegar, brush the hole, rinse the brush in clean
water, and then use the wet rinsed brush to rinse the hole.
Fill the bath with water to the top row of airjets. Drain the bath and press the purge button.
For detailed cleaning information and products to consider, visit www.kohler.com/clean. To order Care &
Cleaning information, call 1-800-456-4537.
Kohler Co. 7 1087307-5-F