Electromagnetic Fields (Emf); Built-In Safety Lock; General Description (Fig. 1); Using The Appliance - Philips HR2020 Manual Del Usario

- If food sticks to the wall of the blender jar, switch off the appliance and unplug it. Then use a
spatula to remove the food from the wall.
- Always make sure the lid is properly assembled on the jar and the measuring cup is inserted
properly in the lid before you switch on the appliance.
- Never forget to place the sealing ring on the blade unit before you connect the blade unit to
the blender jar, otherwise leakage will occur.
- Do not let the appliance run for more than 3 minutes at a time.
- Always let the appliance cool down to room temperature between processing cycles.

Electromagnetic fields (EMF)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.

Built-in safety lock

This feature ensures that you can only switch on the appliance if you have properly assembled the
blender jar on the motor unit. If the blender jar is correctly assembled, the built-in safety lock will be
unlocked.

General description (Fig. 1)

a Measuring cup
B Lid of blender jar
C Blender jar
D Level indication
E Sealing ring
F Blade unit
g Motor unit
H Control panel
- Speed buttons (1 and 2)
- Pulse/off button
Before first use
Thoroughly clean the parts that come into contact with food before you use the appliance for the
first time (see chapter 'Cleaning').

Using the appliance

You can adjust the length of the cord by winding part of it round the reel in the base. Pass the cord
through the slot in the base.
Blender
The blender is intended for fine pureeing, chopping and blending. With the blender you can prepare
soups, sauces and milk shakes. You can also use it to process vegetables, fruit, meat, pancake batter
etc.
Preparing the blender for use
1 Assemble the sealing ring on the blender blade unit (Fig. ).
 Put the blade unit in the bottom of the blender jar (1). Screw the blade unit anticlockwise ()
until it is fixed properly (Fig. 3).
 Put the blender jar with the blade unit attached on the motor unit and fix it by turning it
clockwise ('click') (Fig. ).
EnglisH