Ego Power+ ST1200 Manual Del Usuario página 23

5. hook the folded end of the cutting
line onto either of the slots in the
spool (Fig. 18).
6. Wind the line, in two even and tight
layers, onto the spool. Wind the line
in the direction indicated on the
spool (Fig. 18).
NOTICE: Failure to wind the line in the
direction indicated will cause the bump
head to operate incorrectly.
7. Place the ends of the line in two
opposite notches in the spool,
with approximately 4 in. (10cm)
protruding (Fig. 19).
8. Align the notches of the spool from
which the lines protrude with the
eyelets in the spool retainer and
position the spool in the retainer
(Fig. 20).
18
19
20
Eyelet
56V LiThiUM-iOn cORdLEss 12" sTRing TRiMMER
Wind direction
4" (10 cm)
notch
notch
Eyelet
23