Ego Power+ ST1200 Manual Del Usuario página 8

◾ ◾
check damaged Parts – Before further use of the trimmer, a guard or other part
that is damaged should be carefully checked to determine that it will operate
properly and perform its intended function. check for alignment of moving parts,
binding of moving parts, breakage of parts, mounting, and any other condition
that may affect its operation. A guard or other part that is damaged should be
properly repaired or replaced by an authorized service center unless indicated
elsewhere in this manual.
◾ ◾
clear the area to be cut before each use. Remove all objects such as rocks, broken
glass, nails, wire, or string that can be thrown or become entangled in the cutting
attachment. Make sure that other persons and pets are at least 100 ft. (30.5m) away.
◾ ◾
Always hold the trimmer firmly, with both hands on the handles while operating.
Wrap your fingers and thumbs around the handles.
◾ ◾
Avoid Accidentally starting–don't carry the trimmer with your finger on the trigger.
◾ ◾
do not operate the trimmer in gaseous or explosive atmospheres. Motors in these
appliances normally spark, and the sparks might ignite fumes.
◾ ◾
damage to Trimmer– if you strike a foreign object with the trimmer or it becomes
entangled, stop the tool immediately, check for damage and have any damage
repaired before further operation is attempted. do not operate with a broken
guard or spool.
◾ ◾
if the equipment should start to vibrate abnormally, stop the motor and check
immediately for the cause. Vibration is generally a warning of trouble. A loose
head may vibrate, crack, break or come off the trimmer, which may result in
serious or fatal injury. Make sure that the cutting attachment is properly fixed
in position. if the head loosens after fixing it in position, replace it immediately.
never use a trimmer with a loose cutting attachment.
◾ ◾
Replace a cracked, damaged or worn-out cutting head immediately, even if
damage is limited to superficial cracks. such attachments may shatter at high
speed and cause serious or fatal injury.
◾ ◾
check the cutting attachment at regular short intervals during operation, or
immediately if there is a noticeable change in cutting behavior.
◾ ◾
When replacing the cutting line, use only EgO AL0800 or AL0801 0.080" nylon
line; using heavier lines than recommended by the manufacturer increases the
load on the motor and reduces its operating speed. This results in overheating
and damage to the trimmer.
8
56V LiThiUM-iOn cORdLEss 12" sTRing TRiMMER