Inficon GAS-Mate Guia De Inicio Rapido página 3

Included In The Package:
• GAS-Mate
• Plastic carrying case
• Two Duracell
• Combustible gas sensor (pre-installed)
WARNING!:
1. Install Two "D" Cell Alkaline Batteries (Included)
a. Depress the release tab using a coin or screwdriver.
b. Slide the battery cover away from the probe tip to remove.
c. Insert batteries according to illustration inside battery
compartment.
d. Replace battery cover. Be sure to slide the battery cover
along the side rails until the release tab is engaged.
2. Turning GAS-Mate On and Preparing for Use
a. Long press the power button to turn GAS-Mate On or Off.
The Battery indicator will illuminate while GAS-Mate is On.
NOTE:
GAS-Mate should be turned On in an area free of
combustible gases.
NOTE:
If the Battery indicator flashes or if the Battery and
highest signal indicator both flash, the batteries are
low and should be replaced.
b. Allow GAS-Mate to warm-up from thirty seconds up to
two minutes.
NOTE:
GAS-Mate will alarm during warm-up and the
highest leak indicator will illuminate. When warm-up
is complete, GAS-Mate will beep steadily.
®
MN1300 "D" cell alkaline batteries
To prevent ignition of a hazardous
atmosphere, batteries must only be changed
in an area known to be nonhazardous (i.e.,
completely free of combustible gas).
3