Connection Setup For Power Supply Mode - Victron energy Orion-Tr Smart 12/12-18 Manual

4. Installation
4.1 General
• Mount vertically on a non-flammable surface, with the power
terminals facing downwards. Observe a minimum clearance of
10 cm under and above the product for optimal cooling.
• Mount close to the battery, but never directly above the battery
(in order to prevent damage due to gassing of the battery).
4.2

Connection setup for power supply mode

1. Disconnect the remote on/off (remove wire bridge).
2. Connect the input supply cables.
3. Open the VictronConnect App to setup the product.
(always adjust the output voltage before connecting in
parallel or connecting a battery)
4. Connect the load. The converter is now ready for use.
5. Reconnect the remote on/off to activate the product.
Figure 1: Typical connection setup as DC-DC converter
7