Using Your Alarm Clock - Home HME040078N Manual Del Usuario

Using Your Alarm Clock

Set Up Your Clock
1. Insert one CR2032 battery into the
clock. Refer to the diagram for exact
placement. (Note that the battery is
for backup power only.)
2. Place clock on a bedside table.
3. Connect to DC 5V power.
Set the Time
1. Hold the current time button for 3
seconds until the hour time begins
to blink.
2. Use (+) and (-) to adjust the hour.
3. Touch the current time button to
confirm the hour time and move on
to minutes.
4. Use (+) and (-) to adjust the minutes.
5. Touch the current time button once
more to confirm.
Set Your Alarm Time
1. Touch the alarm option button to
turn on alarm mode. The alarm time
will display for 2 seconds.
2. To adjust the alarm time, hold the
alarm option button for 3 seconds.
3. Use (+) and (-) to adjust the time.
4. Press the alarm option button to
confirm.
Set Your Alarm Tone
1. Press the alarm tone button to
choose a tone.
2. Use (+) and (-) to select between 7
sounds. Tone 1-6 consist of nature
sounds, while tone 7 plays FM radio.
"How to Program the Radio" (pg. 8)
3. Wait for clock to return to standby
mode, then press
volume. You must not be in "Tone",
"Light", "Radio", or any other mode.
4. Press the alarm tone button to
confirm your tone.
NOTE: Alarm volume and radio
volume are adjusted separately.
or to adjust
Program Sunrise Light Simulation
Sunrise light simulation will
automatically occur 30 minutes before
the programmed alarm time. During
this time, the light will switch on and
increase to maximum brightness just
before the alarm sounds.
Adjust Sleep Timer
1. Touch the sleep timer button to
initiate sunset simulation.
2. Touch the sleep timer button once to
set at 15 minutes. Light will gradually
dim until it turns off over the course
of 15 minutes.
3. Touch the sleep timer button a
second time for sunset simulation
over 30 minutes.
4. Touch the sleep timer button three
times for 60 minutes.
5. Touch the sleep timer button four
times to turn off.
6. Leave for 5 seconds to confirm
selected option.
Adjust Light
1. Press the light button once to turn on
the light.
2. Use (+) and (-) to adjust between 10
levels of brightness.
3. Press the light button a second time
to switch on light colors.
4. Use (+) and (-) to choose between
6 colors: green, red, blue, purple,
orange, and indigo.
Adjust Display Brightness
1. Press the display brightness button to
choose between three different LED
display intensities: low, high, and off.
2. The clock will automatically display
the brightest intensity during
programming, but will resume to the
chosen option after 5 seconds.