Moving The Wet/Dry Vac; Blowing Feature - RIDGID RT14000 Manual Del Usuario

OPERATION

Moving the Wet/Dry Vac

Should it become necessary to pick
the Vac up to move it, the Handles
on each side of the Dust Drum or the
Powerhead Carry Handle should be used
to lift.
To maneuver the Vac, the Cart Push
Handle in the rear of the Vac should be
used.
SP7080-1 RT14000 2019.indb 14
Cart Push
Handle
Carry
Handle
Dust Drum
Handles (2)

Blowing Feature

Your Vac features a Blowing Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blowing Port, at the rear of
the Powerhead of your Wet/Dry Vac.
2. Align the Hose Release Button of the
Professional Locking Hose End with the
Ridges on the Blower Port. Push the Hose
End straight into the Blower Port until the
Hose Release Button fully engages the
Blower Port Ridges.
3. (Optional) Attach the Extension Wand
to swivel end of the Hose. See Locking
Accessories section of this manual for
instructions on connecting the Locking
Accessories.
4. Turn the Vac on and you are ready to
use your Vac as a Blower.
WARNING:
!
Always wear
complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before using as
a blower.
WARNING:
!
To reduce the risk of injury to
bystanders, keep them clear of
blowing debris.
CAUTION:
!
Wear a dust mask if blowing creates
dust which might be inhaled.
CAUTION:
!
To reduce the risk of hearing damage,
wear ear protectors when using the
Vac/Blower for extended time or in a
noisy area.
14
safety eyewear
4/22/19 8:35 AM