SATA J Serie Manual Del Uso página 16

10. Drilling operation:
When drilling on the surface of hard material, first mark the area where you want to drill with the pointed punch and hammer to
prevent the bit from slipping. Hold the hand drill, align the bit tip with the mark, and press the switch to drill. Drill with the
appropriate pressure. Do not apply excessive pressure or deviated pressure to increase the diameter.
Note:
The intact high-speed steel bit shall be used for the drilling on metal. For the short screwdriver bit, use a magnetic
connecting rod （ not included） . When tightening the screw, apply a little soap or other lubricant to the thread to facilitate the
operation.
Question and answer:
1. Why does the machine not operate after the switch is pressed?
A reversing yoke is located on the upper part of switch. It is locked. Turn it to the position where the rotation is in need, and then
press the button to rotate the machine.
2. Why does the hand drill stop when the screw has not been tightened?
The machine has low-voltage protection. When the level of battery pack is too low, the machine will not work. Please confirm the
level of battery pack.
16
51006
中文
EN DE RU KO PT JA ES