Fault Finding Chart; Error Codes - BH FITNESS G6324 Manual Del Usuario

FAULT FINDING CHART

PROBLEM
1.The monitor does not
switch on.
2.The monitor switches
on but the motor fails
to start.
3.Walking motion is
jerky on the
treadmill.
4.The machine stops
(the breaker trips).
5.Electrical shocks
through the handrail.
6.The treadmill belt
skews off centre.

ERROR CODES

Monitor screen display
E1
Monitor screen display
E2
Monitor screen display
E3
Monitor screen display
E5
Monitor screen display
E7
Do not hesitate to get touch with the Technical Assistance Service if you have any
queries by phoning customer services (see last page in manual).
CHECKS
1) Make sure that the
machine is plugged in, the
ON/OFF switch in position 1
and that the safety key is
inserted.
2) Check that the current
limiter is pressed in.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on the
sliding belt.
3.c) Check the tension on the
drive belt.
4) Check that the band is
lubricated.
5) Check that the machine is
plugged into an earthed
mains socket.
6.a) Check that the machine
is level on the floor.
6.b) Check that the machine
does not wobble.
Possible cable fault.
Burst clash.
No speed sensor signal
Possible motor overload.
Safety key.
1) Plug the machine into the
mains supply. Set the switch to
position 1 and insert the safety
key.
2) Switch the machine off and
press the circuit breaker in.
Lubricate the treadmill band.
3.a) Lubricate the sliding belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt tension.
4) Reset the overload button with
the On /Off switch at „0" and
lubricate the treadmill band.
5) Plug the machine into an
earthed mains socket.
Connect the wire well between top
controller and bottom controller
Operating with incorrect voltage; Connect
the motor wire again.
Replace the sensor light on the bottom
controller or speed sensor.
Lubricate the belt.
Insert the safety key.
12
SOLUTIONS