Bissell POWERFORCE HELIX TURBO REWIND PET 2692 Serie Guia Del Usuario página 6

Using the Automatic Cord Rewind
1
To plug your vacuum in, gently pull the
cord out of the Automatic Cord Rewind
storage area and stop at the yellow
mark on the cord. Do not pull past the
red mark. Once you have the desired
amount of cord, plug it into the outlet.
Using Your Cleaner
1
Press the red Power Switch Pedal with
your foot to turn ON the unit. Press it
again to turn your vacuum OFF when
you've finished cleaning.
NOTE: Some frieze and berber carpets have long delicate fibers or threads that may
be damaged by rotating brush. Repeated strokes in the same area may enhance this
condition.
NOTICE
The Brush Roll will continue to rotate while you use your vacuum for above floor cleaning. To prevent carpet
damage, do not lean on the vacuum or let the foot of the vacuum tilt forward.
WARNING
position and that all filters, both pre and post-filters, are in place. DO NOT operate your vacuum without
these filters.
WARNING
risk of injury from moving parts, always move the vacuum with the carry handle at the front of the unit.
To prevent carpet damage, do not lean on the vacuum or let the foot of the vacuum tilt forward. Always
place the vacuum on the floor with the handle in the upright position when using tools. Never place your
fingers under the vacuum when it is running. Never place the foot of the vacuum on furniture or uneven
surfaces. Do not place vacuum cleaner close enough to objects to pull them into rotating brush.
6
www.BISSELL.com
Before using your vacuum, make sure that the Dirt Tank is in locked
The Brush Roll continues to rotate while tools are in use. To reduce the
2
When you finish using your vacuum,
unplug it from the outlet. Hold onto
the plug and press the Automatic Cord
Rewind Button until it's fully retracted. If
the cord doesn't fully retract on the first
try, pull a little bit of cord out and press
the button.
2
Press the Handle Recline Pedal to lean
your vacuum back for cleaning. To get
even lower, press the pedal a second time.
When you're finished, lean it all the way
back up to lock it into the upright position.