Publicidad
Idiomas disponibles
Idiomas disponibles
6. Reinstall nozzle andin-line filterintonozzle
extension.
7. Reconnect nozzle extension to spraygun.
8. Reconnect watersupply, t urnonwater, a ndstart
engine.
9. Testpressure washer byoperating w itheach
quickconnect n ozzle.
O-Ring
Maintenance
Purchase an O-Ring Repair Kit at your local Sears or by
calling 1-800-4-MY-HOME (469-4663) or online at
www.sears.com. It is not included with the pressure
washer. This kit includes replacement o-rings, rubber
washer and water inlet filter. Refer to the instruction
sheet provided in the kit to service your unit's o-rings.
i
WARNING
i
• NEVER
repair
leaking
connections
with sealant
of any
kind. Replace
o-ring
or seal.
Pump Maintenance
This model does not require any pump maintenance.
The pump is pre-lubricated and sealed, requiring no
additional lubrication for the life of the pump.
ENGINE MAINTENANCE
WARNING
WHEN ADJUSTING OR MAKING REPAIRS TO YOUR
PRESSURE WASHER
Disconnect the
spark plug
wire from the
spark
plug
and
place
the wire where it cannot contact
spark plug.
WHEN TESTING FOR ENGINE SPARK
Use
approved
spark
plug
tester.
DO NOT check for
spark with spark
plug
removed.
Oil
Oil Recommendations
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, SG, SH, SJ or higher. DO NOT use
special additives.
Choose a viscosity according to the following table:
>F
20
0
20
32
40
60
80
100
°C
30
20
_0
0
/0
20
30
40
STARTING
TEMPERATURE
RANGE
ANTICIPATED
BEFORE
NEXT
OIL CHANGE
NOTE: Synthetic oil meeting ILSAC GF-2, API
certification mark and API service symbol with "SJ/CF
ENERGY CONSERVING" or higher, is an acceptable
oil at all temperatures. Use of synthetic oil does not
alter required oil change intervals.
* The use of multi-viscosity oils (5W-30, 10W-30, etc.)
in temperatures above 40°F (4°C) will result in higher
than normal oil consumption. When using a multi-
viscosity oil, check oil more frequently.
** If using SAE 30 oil in temperatures
below 40°F
(4°C), it will result in hard starting and possible engine
bore damage due to inadequate lubrication.
Checking Oil Level
Oil level should be checked prior to each use or at least
every 5 hours of operation. Keep oil level maintained.
1.
Make sure pressure washer is on a level surface.
2.
Remove oil dipstick and wipe dipstick with clean
cloth. Replace and tighten dipstick. Remove and
and check oil level.
3.
Verify oil is at "Full" mark on dipstick. Replace and
tighten dipstick.
Adding Engine Oil
1.
Make sure pressure washer is on a level surface.
2.
Check oil level as described in "Checking Oil Level".
3.
If needed, slowly pour oil into oil fill opening to the
"Full" mark on dipstick. DO NOT overfill.
4.
Replace and tighten dipstick.
18
Publicidad
