Duramaxx 10029917 Manual Del Usuario página 16

According to the need,the user can align
the silver button on the lower stem at a
group of holes on the middle stem, and ad-
just the length of the aluminum stem.Wind
the cable of the search coil around the alu-
minum stem,elastic moderate,so that the
cable won't sway. Adjust the depth of the
lower stem inserted to the middle stem.
Also,you can adjust the total depth of the
stem,make you detect comfortable with
your arm straight.
Batteries
A section of 9v 6F22 battery (not included) as the power supply for the detector.
1. Set the "SENS" switch in the position of "OFF".
2. Unscrew the battery cover in the direction of the arrow.
Push a 9v battery into the battery cap,according to the
battery polarity symbols.
3. Note: the battery cap attachment should be placed
above,push into the battery box(See Fig.8).
4. Install the battery cover. The battery cover is provided
with a waterproof rubber gasket, it should be tightened
with a key.
Note: Battery box installed correctly,it is very important for the waterproof performance of
the battery box.The correct method is:tighten the battery cover by hand,and you will feel
the force of the rubber gasket being compacted.When you can't rotate it by your hand,use
the accessory supplied key to tighten
16
Step 5 Step 6
The bracket arm has three positions.The
initial bracket arm locates at the longer
position.If your arms are shorter,such as
women, children, you can adjust the po-
sition of the bracket arm.Release the tri-
angle fasten screws under the bracket arm
when adjusting,make the bracket arm to
loose up and down.And remove the bra-
cket arm,adjust the bracket arm forward
to another position.And then tighten the
triangle fasten screws