Replacement Filter Assembly - RIDGID WD1851 Manual Del Operador

SP6673-1 ES 0108.qxd 1/24/08
Unpacking and Checking Carton
Contents (continued)
Key Description
Carton containing the following parts:
P Storage Bag .................................1
R 8" Wheel.......................................2
S Metal Handle................................1
T Axle ..............................................1
U Caddy, Right ................................1
V Caddy, Left ...................................1
Key Description
Bag of Loose Parts -
Containing the following:
W 2" Caster ......................................2
X 1/2" Cap Nut ................................2
Y Wheel Caps .................................2
Z Screw, Type AB #10 x 1-3/4 ........4

Replacement Filter Assembly

1. Carefully slide the filter over the filter
cage, sliding it over the center ring
covering the 3 slots until the filter stops
against the lid.
2. Place filter nut onto threaded stud and
tighten it down. Finger tighten only.
NOTE: Lever of filter nut should be away
from plate as shown.
IMPORTANT: Do not overtighten as this
may deform or crack the filter cage, or
filter.
NOTE: If filter cage needs to be removed,
because the float is placed in the wrong
way, use a flat blade screwdriver and
insert the blade near one of the tabs
between the filter cage and the center
ring of the lid. Pry the tab out of the slot.
Tilt the cage and lift away from the lid.
1:52 PM Page 5
Qty
Qty
X
Filter Nut
Lever
5
U
V
R
S
P
T
Y
Z
W
Filter Nut
Filter
Threaded Stud
Filter Cage
Slots (3)