Wet/Dry Vac Assembly; Insert Hose; Operation - RIDGID WD1851 Manual Del Operador

SP6673-1 ES 0108.qxd 1/24/08

Wet/Dry Vac Assembly

1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Drum
Latch
Powerhead
Assembly
Latch
Drum

Operation

To reduce the risk of fire or explosion, do not operate this vac in areas with
flammable gases, vapors or explosive dust in the air. Flammable gases or
vapors include but are not limited to; lighter fluid, solvent type cleaners,
oil-base paints, gasoline, alcohol or aerosol sprays. Explosive dusts include
but are not limited to; coal, magnesium, aluminum, grain or gun powder.
Do not vacuum explosive dust, flammable or combustible liquids or hot
ashes. Do not use this vac as a sprayer. To reduce the risk of health hazards
from vapors or dusts, do not vacuum toxic materials.
1:52 PM Page 9

Insert Hose

Insert the push button end of the "Tug-A-
Long" hose into the inlet of the vac. The
hose should snap into place. To remove
the hose from the vac, press the release
button in the hose assembly and pull the
hose out of the vac inlet, as shown.
Drum
Press
Latch
and
Pull
Drum
Flange
WARNING
!
9
Release
Button