Descargar Imprimir esta página

General Maintenance - EGO POWER+ CH2100E Manual Del Operador

Ocultar thumbs Ver también para POWER+ CH2100E:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 22
Self-main-
Off
tenance
CHARGING A HOT OR COLD BATTERY PACK
If the battery pack is out of the normal temperature range,
the red LED will shine and the green LED will go off. When
the battery pack cools down to approximately 57°C or
warms to more than 3°C, the charger will automatically
begin charging.
DEFECTIVE BATTERY PACK OR CHARGER
If the charger detects a problem, the red LED will begin
flashing and the green LED will go off.
1. If registering as defective, remove and reinsert the
battery pack in the charger. If the LEDs still read
"defective" a second time, try charging a different
battery pack.
2. If a different battery pack charges normally, dispose
of the defective battery pack (refer to the instructions
in the battery pack manual).
3. If a different battery pack also indicates "defective",
unplug the charger and wait until the red LED goes
out, then reconnect the plug to the power supply. If
the red LED on charger still display defective, the
charge may be defective.
WALL-MOUNT HOLES
The charger has hanging holes for convenient storage
(Fig. A-5). Install screws in the wall 76mm apart. Use
screws sufficiently strong to hold the combined weight of
the charger and battery pack (approximately maximum
3.3kg).
MAINTENANCE
WARNING:
To avoid serious personal injury, always
remove the battery pack from the tool when cleaning or
performing any maintenance.
WARNING:
When servicing, use only identical EGO
replacement parts. Use of any other parts may create a
hazard or cause product damage.
WARNING:
It is not recommended to use
compressed dry air as a cleaning method of the charger. If
cleaning with compressed air is the only method to apply,
always wear safety goggles or safety glasses with side
shields when cleaning the tool. If the operation is dusty,
also wear a dust mask.
Intermittently
Off
quick flashing
WARNING:
If the supply cord is damaged, it must
be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating oils,
etc. come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in
serious personal injury.
WARNING:
When servicing, use only identical EGO
replacement parts. Use of any other parts may create a
hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified
service technician at an EGO Service Center.
Protecting the environment
Do not dispose of electrical equipment,
battery charger and batteries/rechargeable
batteries into household waste!
According to the European law 2012/19/
EU, electrical and electronic equipment
that is no longer usable,and according to
the European law 2006/66/EC, defective
or used battery packs/batteries, must be
collected separately.
If electrical appliances are disposed of in
landfills or dumps, hazardous substances
can leak into the groundwater and get into
the food chain, damaging your health and
well-being.
56 VOLT CHARGER — CH2100E
Battery pack is performing
self-maintenance or in sleep
mode. Reinstall the battery
EN
pack on the charger to
recharge it fully.
7

Publicidad

loading