Introduction; Standard Features - DART Controls 730 BLMC Serie Manual Del Usuario

Dart Controls 730BLMC Series is a general purpose brushless motor control and brushless motor
combination. The control commutates power into a standard 3 phase configuration to run the sensored
brushless (BLDC) motor.
This BLMC Series uses DC power sources of 24VDC Power Supply or a 24V Battery. The BLMC Series
will supply up to 9.0 amperes of continuous current to the motor. The control is rated for NEMA 4X and
the motor is rated for IP66 environmental conditions.
A 14 position terminal strip connects the control to the DC power source, the motor and the speedpot.
There is a ¼" spade pin that can be used for inhibiting the control. There is a 1/8" spade pin that can be
used to brake the control. The control's PC board carries the minimum speed, maximum speed and current
limit trimpots for the BLMC, a gain trimpot, as well as Accel and Decel trimpots for the BLMC.
● POWER MOSFET TRANSISTORS
● QUIET 17KHz "PULSE WIDTH MODULATED" SWITCHED FREQUENCY
● FORWARD/REVERSE DIRECTIONAL CONTROL
● 5KΩ SPEED POTENTIOMETER W/ DIAL & KNOB
● ANODIZED CHASSIS
● INHIBIT INPUT PIN FOR START/STOP OPERATION
● BRAKE INPUT PIN FOR QUICK STOP OPERATION
● INTERNAL +6.2 VOLT DC SUPPLY FOR MOTOR HALL EFFECT SENSORS

Introduction

Standard Features

2