Features; Sensor Spacing & Input Voltage Selection; Speed Command Selection And Hook-Up - DART Controls 730 BLMC Serie Manual Del Usuario

P1
1 2
Sensor Spacing & Input Voltage Selection
Normally the BLMC Series control is shipped ready for 120
drive can be configured to work with a motor with 60
The input voltage is also jumper selectable and is shipped with the standard setting of 24/48VDC input
(P3-2 and P3-3 connected). See Figure 2 of the Hook-Up Diagram section for location of the selectable
input voltage connector and attached jumper connector.

Speed Command Selection and Hook-up

The BLMC series control operates with a 5K potentiometer (supplied with control) or a 0 to 5VDC power
source. The 5K ohm speedpot in the cover is connected to terminals P1-12, P1-13, and P1-14 of the
control. Connect the speedpot "LO" lead (orange wire) to terminal P1-14, the speedpot "WIPER" lead (red
wire) to P1-13, and the speedpot "HI" lead (white wire) to P1-12. A 0 to 5V DC signal can also be used
to regulate the speed. This is accomplished by connecting the DC source signal lead to terminal P1-13
(WIPER) and the common lead to terminal P1-14 (LO).
Note: A 5K ohm resistor must be connected from the Pot Hi terminal (P1-12) to the Pot Lo terminal (P1-
14) for proper operation of the Min trimpot.

Features

3 4 5 6 7 8 9 10 11 12 13 14
P10
P2
P7
3 2 1
P3
3 2 1
Figure 2
o
sensor spacing (P2-2 and P2-3 connected). The
o spacing by connecting P2-2 to P2-1 with a jumper.
5
Brake
o o
60 /120 Phase
Inhibit
Voltage Selection